[Mod] Converter Minecraft world to Minetest world

[sofar]

is there a simple set of instructions on how to use this?

not sure if you're talking about my mcimport.py here, but if you are, please look at the bottom of this post:

https://forum.minetest.net/viewtopic.php?f=14&t=13709

[mongus]

Hi, so I've had a bash at converting a fairly small map. It took a couple of minutes to install. There were a fair few Unknown Minecraft Block messages. I have downloaded and enabled the mods.

But, when I run the map I get nothing. I am in a completely empty world. I can look up and see the sun and clouds. All around I have blue and below there is a darker blue rectangle. It is as though none of the block got converted over.

I have tried the trick mentioned by dgm5555 an page 1 of this thread to show unknown blocks. No unknown blocks are shown.

I'm pretty sure it is a 1.8.9 map.

Any ideas what could be going wrong?

[sofar]

Hi, so I've had a bash at converting a fairly small map. It took a couple of minutes to install. There were a fair few Unknown Minecraft Block messages. I have downloaded and enabled the mods.

But, when I run the map I get nothing. I am in a completely empty world. I can look up and see the sun and clouds. All around I have blue and below there is a darker blue rectangle. It is as though none of the block got converted over.

I have tried the trick mentioned by dgm5555 an page 1 of this thread to show unknown blocks. No unknown blocks are shown.

I'm pretty sure it is a 1.8.9 map.

Any ideas what could be going wrong?

Could you potentially send me a zip file with the world zipped up? If it's small enough you could even upload it to this forum.

EDIT: It's entirely possible that minecraft put your small world a few 100 blocks away from 0,0,0 and so your world is converted without problems, except there's nothing near the minetest spawn location. Load the world in MC and move to 0,0,0 and look around.

Also, please check that you're not just stuck inside the ground - enable noclip and free movement and try and move out of blocks. Maybe enabling the minimap helps, as well.

[sofar]

Hi, so I've had a bash at converting a fairly small map. It took a couple of minutes to install. There were a fair few Unknown Minecraft Block messages. I have downloaded and enabled the mods.

But, when I run the map I get nothing. I am in a completely empty world. I can look up and see the sun and clouds. All around I have blue and below there is a darker blue rectangle. It is as though none of the block got converted over.

I have tried the trick mentioned by dgm5555 an page 1 of this thread to show unknown blocks. No unknown blocks are shown.

I'm pretty sure it is a 1.8.9 map.

Any ideas what could be going wrong?

If you're using my version (github.com/sofar/mcimport), can you please start a thread in this topic instead? -> viewtopic.php?f=12&t=13709&hilit=mcimport

While the original code base is the same it's better to have the discussion where it's relevant.